Looking for a 6-gauge setup for your 1st Generation Mustang but not wanting to stray so far away from that correct stock Ford Look?
You found the solution to your wants.
Using my proprietary aftermarket gauge mounting system especially designed to install SpeedHut gauges onto our original (or reproduction) 65 & 66 Mustang bezels, I have these gauges made to look as close as possible to the original Ford Mustang gauges while giving us the modern technology our Restomods demand.
Each gauge is special made to my specs so they look and feel like the originals while providing accurate vitals. I have altered my proprietary mounting system that allows me to install these SpeedHut gauges in any stock or reproduction 1966 Mustang bezel.
The Speedometer/Tachometer Combo gauge being a GPS speedometer does not require you to change out your existing cable or purchase any additional speed sending unit. The tach will wire up as any usual tack does and all the other gauges will come with their required sending units as well.
This is truly a Classic Retro Turnkey package.
Since I have only brought this to market early 2026, it will really stand out at shows since it is likely nobody else will have this in there Pony.
Be advised that it does take time to build each gauge set (nothing is sitting on the shelf) so I like to set expectations as it takes SpeedHut approx 4-5 weeks to build my gauge sets. Often times, they do come in early but if you're looking for an off the shelf mass produced solution to throw into your Mustang, this is NOT for you.
However, if you want quality and classic, then here is what is included in this bundle
- ACP Reproduction Bezel of choice (65GT, 66 Standard or 66 Pony Deluxe woodgrain)
- HyePo CPS Proprietary Mounting System especially designed for SpeedHut Gauges
- SpeedHut GPS Speedo/Tach Combo 6 Instrument Gauge Set - Made in the USA
- Speedo/Tach 4" Combo with Early 60's Ford style faces (red pointer)
- Fuel Level 2-1/16" with Early Ford Inverted Sweep (red pointer)
- Oil Pressure 2-1/16" (with sending unit) with Early Ford Inverted Sweep (red pointer)
- Voltmeter 2-1/16" with Early Ford Inverted Sweep (red pointer)
- Water Temperature 2-1/16"(with sending unit) with Early Ford Inverted Sweep (red pointer)
- Downloadable Wiring Instructions for 66 Mustangs
This package will be FULLY assembled ready to be wired and installed when it arrives to you.
All gauges come with their necessary sending units including the GPS antenna for the Speedometer/Tachometer combo gauge
Please allow 4 to 5 weeks for gauges to be made and shipped from Utah to our Central California location for final assembly.
